![]() (without file name extension) will not accomplish the desired result Įxecuting ls (without file name extension) will fail. Syslinux will try first to find the exact file name as typed-in,Īnd if it is not found then Syslinux will search for a matching fileĪccording to the above list of file name extensions, in the specified order.Ĭonversely, renaming the ls.c32 file to ls When executing ls (without file name extension) in the CLI, In this case, typing-in mylabel (or executing it from a boot menu) The ls file name (without extension) is not present.Īs the KERNEL directive is generic and does not expect a specific file type. Since the COM32 directive expects this type of files (.c32 modules) and Then typing-in mylabel (or executing it from a boot menu) Note that the above command lacks file name extension, i.e. This feature is valid for kernel-like directivesĪ file named " ls" (without file name extension) does not exist, This feature is valid when typing commands directly in the CLI. Syslinux will attempt to append file name extensions to the specified file name Their configuration file and still have things work correctly.įor kernel-like file names given on the command line, This method allows users to omit the PATH directive from Install all library files in the Syslinux installation directory, The reason that things work this way is that typically a user will Is specified in the PATH directive of a configuration file. The CWD is not affected when specifying a file with an absolute path.įor example, given the following file system layout,Īssuming that the current working directory is There is a need to tell the main modules where to search for theirĪccording to the directory structure that the user sets up. With the introduction of c32 dependencies (or " library modules"), The PATH directive is not a replacement for using The PATH directive applies to all c32 modules, and only to them. Since there is no absolute distinction between "main" c32 modules Which are dependencies of other c32 modules. The objective of the PATH directive is to search for This is also valid for the command line interface. Reboot the system in an attempt to restart the boot process andĪll (paths to) file names inside the configuration file are relative to the Working Directory, Will be the parent directory of pxelinux.0 If no initial configuration file is found, thenĭirectory (where " ldlinux.* " is located). ![]() Will be the directory containing the initial configuration file. When booting, the initial working directory for Note that syslinux.efi could be optionally renamed. sysl圆4.cfg when booting in EFI_圆4 modeīefore falling back to the next directory.syslia32.cfg when booting in EFI_ia32 mode.Is located and containing also its corresponding The configuration file in the installed directory, where Since version 4.03, the resulting behavior is thatĪny of the respective config files (or even all of them)Ĭan optionally be located together in the same Since version 4.03, the resulting behavior is that the sameĪnd/or nf files would take precedence if present. Syslinux.cfg before falling back to the next directory. The first configuration file that is foundĮXTLINUX (merged into SYSLINUX as of 4.00) used SYSLINUX also searches for the config file in (containing ldlinux.sys or extlinux.sys). Note: In the following paragraphs, the " /" directory represents the root of the filesystem in which Syslinux (in its several variants) is (going to be) installed.ĭefault to searching for the config file in the installed directory Erase text from cursor till end of command Display network info Īdditional keystrokes that are supported since version 5.00: ![]() The command line prompt supports the following keystrokes: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |